Channel: Start_stop_voltage_limit value 7.6 v changed to 12 v
The value 7.6 v is a value far to low to run a car so I don’t think this is a voltage value,
more a “scaled” value perhaps some type of percentage.
I have tested it with the value 10 v and the car run okay without any engine stops when I
stopped the car for red lights and smaller traffic jams. After this exercise I changed the
value to 12 v. (Highest acceptable value is 12.1). Then it was time for new tests and the
outcome was good. The “A” symbol “over lined” was shown in the MFD when the car
wasn’t moving as expected during both tests.
This is the only setting at the moment I have changed (regarding S/S), nothing else.
I did also run an error scan this evening, no errors found connected to this change
19 Diagnoseinterface
Anpassung - 10
Anpassungskanal: Start/Stopp Startspannungsgrenze: von 7,6 V auf 12 V geändert.
im Discovery Pro steht nun bei Fahrzeugstatus wenn man auf Start/stopp geht :
Fahrzeugenergiebedarf ist zu hoch
Fahrer ist nicht angeschnallt (dies geht weg wenn ich mich anschnalle *g* )
lg Thomas
Golf 7 GTI Performance Pure white
APR Stage 1
VWR R600 Intake
HJS Downpipe
Alphamale 3 Zoll Klappenauspuffanlage
KW ST 30/30 Federn
VCDS User.
Mache ebenfalls Fahrzeugaufbereitungen.